Analysis of Unconscious Properties and Strength Measurements for Concrete Containing Copper Slag-Review

Abstract

The main aim of the environmental protection agencies and the government are to seek ways and means to minimize the problems of disposal and health hazards of by products. It is considered as a waste material which could have a promising future in construction industry as substitute of either cement or coarse aggregates or fine aggregates. Copper slag is one of the replacement mechanisms of material in concrete. Use of copper slag as a replacement for fine aggregate in concrete cubes various strength measurements was experimentally investigated in this study. Mainly contents of that M35 conventional concrete and copper slag as a replacement of fine aggregate  in 10%, 20%, 30%, 40%,50%, 60%, 80%, and 100% and also Portland Pozzolana Cement is noted. In this regard, laboratory study including water absorption test, bond strength, and percentage of voids, compressive strength & bulk density were conducted in ppc cement concrete which made by copper slag waste as a replacement of fine aggregate and PPC. A substitution up to 40-50% as a copper slag as a sand replacement yielded comparable strength to that of the conventional concrete. However, addition of more copper slag resulted in strength reduction due to the increase in the free water content in the mix, cured period in a curing tank for later resulting at 28 and 60 days.